Warning, Perating, Nstructions – Monessen Hearth B-Vent Specialty Gas Fireplace System DESIGNER SERIES User Manual

Page 19: 6clp c, Nits, With, Ontrols, Nstalled

PERATING

NSTRUCTIONS

LIGHTING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING

IF YOU CANNOT REACH YOUR GAS SUPPLIER, CALL

IF YOU CANNOT REACH YOUR GAS SUPPLIER, CALL
THE FIRE DEPARTMENT.

USE ONLY YOUR HAND TO PUSH IN OR TURN THE GAS

USE ONLY YOUR HAND TO PUSH IN OR TURN THE GAS
CONTROL KNOB. NEVER USE TOOLS. IF THE KNOB WILL

CONTROL KNOB. NEVER USE TOOLS. IF THE KNOB WILL
NOT PUSH IN OR TURN BY HAND, DO NOT TRY TO REPAIR

NOT PUSH IN OR TURN BY HAND, DO NOT TRY TO REPAIR
IT. CALL A QUALIFIED SERVICE TECHNICIAN. FORCE OR

IT. CALL A QUALIFIED SERVICE TECHNICIAN. FORCE OR
ATTEMPTED REPAIR MAY RESULT IN A FIRE OR EXPLOSION.
DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN

DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN
UNDER WATER. IMMEDIATELY CALL A QUALIFIED SERVICE
TECHNICIAN TO INSPECT THE APPLIANCE AND REPLACE

TECHNICIAN TO INSPECT THE APPLIANCE AND REPLACE
ANY PART OF THE CONTROL SYSTEM AND ANY GAS

ANY PART OF THE CONTROL SYSTEM AND ANY GAS
CONTROL WHICH HAS BEEN UNDER WATER.

THE FLOOR.

WARNING:

INSTRUCTIONS.

THIS APPLIANCE HAS A PILOT WHICH MUST BE LIT BY

THIS APPLIANCE HAS A PILOT WHICH MUST BE LIT BY
HAND WHILE FOLLOWING THESE INSTRUCTIONS EXACTLY.

HAND WHILE FOLLOWING THESE INSTRUCTIONS EXACTLY.
BEFORE LIGHTING SMELL ALL AROUND THE APPLIANCE

BEFORE LIGHTING SMELL ALL AROUND THE APPLIANCE
AREA FOR GAS AND NEXT TO THE FLOOR BECAUSE

AREA FOR GAS AND NEXT TO THE FLOOR BECAUSE
SOME GAS IS HEAVIER THAN AIR AND WILL SETTLE ON

SOME GAS IS HEAVIER THAN AIR AND WILL SETTLE ON

WHAT TO DO IF YOU SMELL GAS

DO NOT TRY TO LIGHT ANY APPLIANCE.

DO NOT TOUCH ANY ELECTRIC SWITCH; DO NOT
USE ANY PHONE IN YOUR BUILDING.

IMMEDIATELY CALL YOUR GAS SUPPLIER FROM A

IMMEDIATELY CALL YOUR GAS SUPPLIER FROM A
NEIGHBOR'S PHONE. FOLLOW THE GAS SUPPLIER'S

IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT

IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT
CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.

CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.

TO TURN OFF GAS TO APPLIANCE

GENERATOR

PILOT

THERMOCOUPLE

PIEZO ELECTRODE

8. DEPRESS AND HOLD GAS KNOB WHILE LIGHTING THE

7. TURN GAS KNOB COUNTERCLOCKWISE TO PILOT.

6. FIND PILOT LOCATED IN FRONT OF THE MIDDLE LOG.

VALVE TURN COUNTERCLOCKWISE TO HIGH.

5. IF APPLIANCE IS EQUIPPED WITH HI-LO ADJUSTMENT

DEPRESSED.

LABEL.

3. TURN GAS KNOB CLOCKWISE TO OFF.

2. TURN OFF ALL ELECTRICAL POWER TO THE APPLIANCE.

BE TURNED FROM PILOT TO OFF UNLESS THE KNOB IS

WHEN LIGHTING AND RELIGHTING, THE GAS KNOB CANNOT

1. STOP! READ THE SAFETY INFORMATION ON THE FIRST

068058

TO ON.

3 THRU 7.

L T

OFF

GAS KNOB "OFF"

CLOCKWISE TO OFF. DO NOT FORCE.

2. PUSH IN GAS CONTROL KNOB SLIGHTLY AND TURN

11. TURN ON ALL ELECTRICAL POWER TO THE APPLIANCE.

THE ON POSITION TO IGNITE BURNER.

VALVE TO ON OR HIGH. REMOTE SWITCH MUST BE IN

BURNER MAY NOT COME ON WHEN YOU TURN THE

10. IF EQUIPPED WITH REMOTE ON-OFF SWITCH MAIN

9. WITH PILOT LIT TURN GAS KNOB COUNTERCLOCKWISE

IF PILOT DOES NOT CONTINUE TO BURN REPEAT STEPS

FULLY DEPRESSED FOR ONE MINUTE, THEN RELEASE.

GAS GO TO THE NEXT STEP.

IF SERVICE IS TO BE PERFORMED.

1. TURN OFF ALL ELECTRICAL POWER TO THE APPLIANCE

MATION ON THE FIRST LABEL. IF YOU DON'T SMELL

SMELL GAS, STOP! FOLLOW "B" IN THE SAFETY INFOR-

SMELL FOR GAS, INCLUDING NEAR THE FLOOR. IF YOU

4. WAIT FIVE (5) MINUTES TO CLEAR OUT ANY GAS. THEN

PILOT WITH THE PUSH BUTTON IGNITOR. KEEP KNOB

NITS

WITH

6CN

AND

6CLP C

ONTROLS

NSTALLED

53D9019.

Rev 3 11/07