Monessen Hearth B-Vent Specialty Gas Fireplace System DESIGNER SERIES - Manual (Page 18)

OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
WARNING:
FOR YOUR SAFETY READ BEFORE LIGHTING FOR YOUR SAFETY READ BEFORE LIGHTING
ON
OFF
TO TURN OFF GAS TO APPLIANCE TO TURN OFF GAS TO APPLIANCE
KNOB KNOB
INDICATOR INDICATOR
POSITION POSITION
GAS CONTROL GAS CONTROL
THE FIRE DEPARTMENT.
HAS BEEN UNDER WATER.
OR EXPLOSION.
CONTROL SYSTEM AND ANY GAS CONTROL WHICH
THE APPLIANCE AND REPLACE ANY PART OF THE
QUALIFIED SERVICE TECHNICIAN TO INSPECT
BEEN UNDER WATER. IMMEDIATELY CALL A
D. DO NOT USE THIS APPLIANCE IF ANY PART HAS
FORCE OR ATTEMPTED REPAIR MAY RESULT IN A FIRE
TO REPAIR IT. CALL A QUALIFIED SERVICE TECHNICIAN.
WILL NOT PUSH IN OR TURN BY HAND, DO NOT TRY
CONTROL KNOB. NEVER USE TOOLS. IF THE KNOB
C. USE ONLY YOUR HAND TO PUSH IN OR TURN THE GAS
IF YOU CANNOT REACH YOUR GAS SUPPLIER, CALL
5. REMOVE CONTROL ACCESS PANEL.
YOU THEN SMELL GAS, STOP! FOLLOW "B" IN THE
SAFETY INFORMATION ABOVE ON THIS LABEL. IF YOU
DON'T SMELL GAS, GO TO NEXT STEP.
7. WAIT FIVE (5) MINUTES TO CLEAR OUT ANY GAS. IF
6. TURN GAS CONTROL KNOB CLOCKWISE TO "OFF". THIS LABEL.
INSTRUCTIONS.
WHAT TO DO IF YOU SMELL GAS
ON THE FLOOR.
2. SET THE ROCKER SWITCH TO "OFF".
CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT
NEIGHBOR'S PHONE. FOLLOW THE GAS SUPPLIER'S
IMMEDIATELY CALL YOUR GAS SUPPLIER FROM A
USE ANY PHONE IN YOUR BUILDING.
DO NOT TOUCH ANY ELECTRIC SWITCH; DO NOT
DO NOT TRY TO LIGHT ANY APPLIANCE.
SOME GAS IS HEAVIER THAN AIR AND WILL SETTLE
AREA FOR GAS AND NEXT TO THE FLOOR BECAUSE
B. BEFORE LIGHTING SMELL ALL AROUND THE APPLIANCE
DO NOT TRY TO LIGHT THE PILOT BY HAND.
DEVICE WHICH AUTOMATICALLY LIGHTS THE PILOT.
A. THIS APPLIANCE IS EQUIPPED WITH AN IGNITION
1. STOP! READ THE SAFETY INFORMATION ABOVE ON
3. TURN OFF THE ELECTRIC POWER TO THE APPLIANCE.
4. THIS APPLIANCE IS EQUIPPED WITH AN IGNITION DEVICE
WHICH AUTOMATICALLY LIGHTS THE PILOT.
068059 068059
TO "ON".
IS TO BE PERFORMED.
9. REPLACE CONTROL ACCESS PANEL.
10. TURN ON ALL ELECTRIC POWER TO THE APPLIANCE.
11. SET THE ROCKER SWITCH TO "ON".
12. IF THE APPLIANCE WILL NOT OPERATE, FOLLOW THE
INSTRUCTIONS "TO TURN OFF GAS TO APPLIANCE" AND
CALL YOUR SERVICE TECHNICIAN OR GAS SUPPLIER.
ELECTRICAL POWER TO THE APPLIANCE IF SERVICE
IGNITION DEVICE OR OPTIONAL BLOWER, TURN OFF ALL
5. IF THE APPLIANCE IS EQUIPPED WITH AN AUTOMATIC
4. REPLACE CONTROL ACCESS PANEL.
2. REMOVE CONTROL ACCESS PANEL.
3. DEPRESS THE CONTROL KNOB INWARD SLIGHTLY
AND TURN CLOCKWISE TO OFF.
1. SET THE ROCKER SWITCH OR WALL SWITCH TO "OFF".
8. TURN GAS CONTROL KNOB COUNTERCLOCKWISE DO NOT TRY TO LIGHT THE PILOT BY HAND.
O
PERATING
I
NSTRUCTIONS
17
F
OR
U
NITS WITH
6CEN C
ONTROLS
I
NSTALLED
53D9019.
Rev 3 11/07