Loning – Motorola CT-39A User Manual

Page 60

FT-8800R Operating Manual

You can transfer all data stored in one FT-8800R to another FT-8800R by utilizing the
handy “Cloning” feature. This requires a user-constructed Cloning cable which connects the
DATA jacks on the two transceivers, as shown below.

To clone from one transceiver to another, use the following procedure:
1. Insert the Cloning Cable into the DATA jack of each transceiver.
2. Turn both transceivers off, then press and hold in the “left” [V/M] key on each radio

while turning the power on again.

3. Rotate the “right” DIAL knob on each radio to select (CLONE START), then press the

[SET] key. The display will disappear for a moment, then the “CLONE” notation will
appear on the display.

4. On the “destination” radio, press the “left” [LOW] key. The “CLONE -RX-” indicator

will appear on the display.

5. Now, on the “source” radio, press the “left” [V/M] key. The “CLONE -TX-” indicator will

appear on the display, and the cloning data transfer will immediately begin.

6. If there is a problem during the cloning process, “CLONE ERROR” will be displayed.

Check your cable connections, and try again.

7. If cloning was successful, the “CLONE -RX-” and “CLONE -TX-” indicators will disap-

pear.

8. Turn both transceivers off, then remove the Cloning Cable. Channel and operating data

for both radios are now identical. They both may be turned on now for normal operation.

13.8VDC

ANT

EXT SP

DATA

13.8VDC

ANT

EXT SP

DATA

PKS

GND

LONING