Motorola CT-39A - Manual (Page 46)

44 FT-8800R Operating Manual
The Smart Search feature may be used to load - automatically with no operator intervention
- a special bank of up to 25 memory channels (per band) on activity.
The Smart Search function will sweep the entire band, and will load the special memory
bank with the frequency and repeater shift data pertaining to those channels on which activ-
ity is found (if Automatic Repeater Shift is activated). The channels are loaded in order in
which they are encountered, not according to signal strength or by ascending frequency.
The Smart Search feature is especially useful when visiting a city for the first time, where
you may be unfamiliar with the repeater frequencies; Smart Search discovers where the
local activity is to be found, and automatically loads those frequencies for you.
Smart Search operation is simple to activate:
1. Set the radio to the VFO mode by pressing the [V/M] key, if necessary.
2. Press and hold in the [V/M] key; this will cause the radio to scan upward on the current
band, loading channels on which it encounters a signal strong enough to open the squelch.
3. When 25 channels are loaded, or when the scanner reaches the band edge, the scanner
will stop and the transceiver will revert to the starting frequency.
4. To recall the Smart Search memories just stored, rotate the DIAL knob or press the
microphone’s [UP]/[DWN] keys (for the “Main” band Smart Search memories only).
5. If you found particular channels which you wish to store into the “regular” memory
channel, follow the memory storage procedures described on page 32.
1) The Smart Search memories are so-called “soft” memories; they will lost if you
exit the Smart Search mode or initiate a new Smart Search sweep.
2) You may activate Smart Search operation on the “Main” band by pressing and holding
in the microphone’s [P2] key.
3) You may activate Smart Search operation on the “left” and “right” bands at the same
time.
S
MART
S
EARCH