Motorola CT-39A - Manual (Page 50)

48 FT-8800R Operating Manual
Sixteen DTMF Autodialer memories are available on the FT-8800R. These DTMF Autodialer
memories can store up to 16 digits of a telephone number for repeater autopatch or other
uses.
To load DTMF Autodialer memories, use following procedure:
1. Press the [SET] key momentarily to enter the Set mode.
2. Rotate the “Main” band DIAL knob to select Menu #15 (DTMF W).
3. Press the “Main” band DIAL knob momentarily, then rotate the “Main” band DIAL knob
to select the DTMF Autodialer memory channel number (“d-1” through “d-16”) into
which you wish store a telephone number.
4. Press the “Main” band DIAL knob momentarily, then rotate the “Main” band DIAL knob
to select the first digit of the telephone number you wish to store.
5. When you have selected the correct digit, press the “Main” band DIAL knob momen-
tarily. Now, rotate the “Main” band DIAL knob to select the second of the 16 available
numbers in this current DTMF Audodialer memory register.
6. Repeat this procedure for each digit in the telephone number. Press the “Main” band
[SCN] key momentarily to delete any previously-stored data after the cursor. If you
make a mistake, press the microphone’s [DWN] key to move back to the first digit, then
re-enter the correct number.
7. When entry of all digits is complete, press the [SET] key momentarily to save the new
setting.
8. If you wish to store another DTMF string, rotate the “Main” band DIAL knob to select
another DTMF memory register, then repeat steps 4 through 7 above.
9. When all required DTMF memories are filled to your satisfaction, press and hold in the
“Main” band DIAL knob for 1/2 second to exit to normal operation.
To transmit the memorized telephone number, use the following procedure:
1. Press the [SET] key momentarily to enter the Set mode.
2. Rotate the “Main” band DIAL knob to select Menu #15 (DTMF W).
3. Press the “Main” band DIAL knob momentarily, then rotate the “Main” band DIAL knob
to select the DTMF Autodialer memory channel to be transmitted.
4. Press and hold in the “Main” band DIAL knob for 1/2 second to exit to normal operation.
5. Press the PTT switch.
6. While still holding the PTT switch in, press the “Main” band [HM] key momentarily to
transmit the tone string.
Once you have pressed the [HM] key in the above step, you can release the PTT switch, as
the Autodialer will transmit the whole DTMF string automatically.
DTMF A
UTODIALER
O
PERATION