GIGABYTE PHASER 4500 - Manual (Page 110)

- 104 - GA-7VAX/GA-7VAXP Motherboard
English
Troubleshooting
If you encounter any trouble during boot up, please follow the
troubleshooting procedures .
Turn off the power and unplug the AC power cable, then remove
all of the add-on cards and cables from motherboard.
START
Failure has been ex cluded.
Yes Please make sure motherboard & chassis are not short ?
No
A
Please make sure all jumper settings (such as CPU system bus
speed, frequency ratio, voltage and etc.) are set properly.
Failure has been ex cluded.
Check if the CPU cooling fan attached to CPU properly. ls
CPU cooling fan power connected to CPU_FAN
properly?
Check if the memory install properly into the DIMM slot.
Yes
No
Yes
Insert the VGA card. Then plug in ATX power cable and turn
on the system.
No
No
Yes
Failure has been ex cluded.
Failure has been ex cluded.
Please isolate
the short pin.
Make sure the
jumper setting
are correct.