GIGABYTE LGA775 Socket Motherboard for Intel GA-73PVM-S2H - Manual (Page 81)

Appendix - 81 -
Step 4:
After the SATA controller driver installation is completed, you can proceed with the Windows XP
installation.
Figure 6
WindowsXP Professional Setup
Enter= Continue R=Repair F3=Exit
Welcome to Setup.
This port of the Setup program prepares Microsoft(R)
Windows (R) XP to run on your computer.
To set up Windows XP now, press ENTER.
To repair a Windows XP installation using
Recovery Console, press R.
To quit Setup without installing Windows XP, press F3.
When the screen as shown below appears, press to continue the driver installation from
the floppy disk. The driver installation will be finished in about one minute.
Figure 5
Windows Setup
S=Specify Additional Device ENTER=Continue F3=Exit
Setup will load support for the following mass storage device(s):
NVIDIA RAID Driver (required)
NVIDIA nForce Storage Controller (required)
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.