GE 1 CBC980 - Manual (Page 37)

37
geappliances.ca
Oven Light Replacement
CAUTION:
Before replacing your
oven light bulb, disconnect the electrical
power to the range at the main fuse or
circuit breaker panel. Be sure to let the
light cover and bulb cool completely.
The oven light bulb is covered with a
removable glass cover that is held in place
with a bail-shaped wire. Remove the oven
door, if desired, to reach cover easily.
To remove:
Hold a hand under the cover so it
doesn’t fall when released. With fingers
of the same hand, firmly push back the
wire cover holder. Lift off the cover.
Do not remove any screws to remove
the cover.
Do not touch hot bulb with a wet cloth.
Replace bulb with a 40-watt household
appliance bulb.
To replace cover:
Place it into the groove of the light
receptacle. Pull the wire forward to
the center of the cover until it snaps into
place. When in place, the wire holds the
cover firmly. Be certain the wire is in the
depression in the center of the cover.
Connect electrical power to the range.
Oven Racks and Drawer Racks
Clean the racks with an abrasive cleanser.
The oven racks may be cleaned in the
self-cleaning oven. However, the racks
will darken in color, lose their luster and
become hard to slide if cleaned during
the self-cleaning cycle.
To make the racks slide more easily, apply
a small amount of vegetable oil or cooking
oil to a paper towel and wipe the edges
of the oven racks with the paper towel.
Wire cover holder.
Operating
Instructions
Car
e and Cleaning
Installation Instructions
Tr
oubleshooting
Tips
Safety Instructions
Consumer S
uppor
t