GE 1 CBC980 - Manual (Page 18)

If a flashing time is in the display, you have
experienced a power failure. Reset the clock. To reset the clock, touch the CLOCK pad.
Enter the correct time of day by touching
the appropriate number pads.
Touch the START pad.
18
Make sure the clock is set to the correct
time of day.
The timer is a minute timer only.
The CLEAR/OFF pad does not affect
the timer.
Not all features are on all models.
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of day
cannot be changed during a timed baking
or self-cleaning cycle.
Touch the CLOCK pad.
Touch the number pads.
Touch the number pads the same way you
read them. For example, to set 12:34, touch
the number pads 1, 2, 3 and 4 in that order.
If number pads are not touched within
one minute after you touch the CLOCK pad,
the display reverts to the original setting.
If this happens, touch the CLOCK pad
and reenter the time of day.
Touch the START pad until the time
of day shows in the display. This enters
the time and starts the clock.
To check the time of day when the display
is showing other information, simply touch
the CLOCK pad. The time of day shows until
another pad is touched.
To Set the Timer
The timer does not control oven operations.
The maximum setting on the timer is 9 hours
and 59 minutes.
Touch the TIMER ON/OFF pad.
Touch the number pads until the
amount of time you want shows in
the display. The maximum number
of minutes that can be entered is 60.
To set additional time, you will need
to set it by hours and minutes.
For example, to enter 1 hour and
30 minutes, touch 1, 3 and 0 in
that order.
If you make a mistake, press the KITCHEN
TIMER ON/OFF pad and begin again.
Touch the START pad. After pressing
the START pad, SET disappears; this tells
you the time is counting down, although
the display does not change until one
minute has passed.
When the timer reaches :00, the control
will beep 3 times followed by one beep
every 6 seconds until the TIMER
ON/OFF pad is touched.
The 6 second tone can be canceled by
following the steps in the Special features
of your oven control section under Tones
at the End of a Timed Cycle.
Using the clock and timer.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by touching
the TIMER ON/OFF pad; then touch the
number pads until the time you want
appears in the display. If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
touching the TIMER ON/OFF pad and then
touching the number pads to enter the new
time you want.
To Cancel the Timer
Touch the TIMER ON/OFF pad twice.
Power Outage
Operating
Instructions
Safety Instructions
Car
e and Cleaning
Installation Instructions
Tr
oubleshooting
Tips
Consumer S
uppor
t