Grizzly G9983 - Manual (Page 34)

-32- G9983 15" Open-End Wide-Belt Sander
NOTICE
New V-belts will often stretch after moder-
ate use. Check frequently after installation.
Figure 29. Remove platen adjustment knob,
indicator plate, and large cap screws.
Figure 31. Remove this roller shaft nut located
behind right-hand access door.
Figure 30. Work the casting off the roller shafts. Figure 32. Remove roller.
6. Work the casting off the roller shafts as
shown in
Figure 30 .
7. Open the right-hand access door and locate
the large nut shown in
Figure 31 and remove
it with the box wrench included with the
machine.
8. Slide out the front roller shaft, as shown in
Figure 32 , to get the V-belts off of the pulley.
9. Installation is the reverse of removal. If pos-
sible, have an assistant help you when
installing the V-belts and the roller. Also, an
assistant can be helpful on the other end of
the roller when tightening the nuts on the
roller shafts.