Gold's Gym XRT 75 GGSY69320 - Manual (Page 23)

23
66. Wrap the Fly Cable (85) over a 90mm Pulley (78).
Attach the Pulley and a Cable Trap (68) between
the lower set of holes in the “U”-bracket (59) with
an M10 x 50mm Bolt (100) and an M10 Nylon
Locknut (87). Make sure that the Cable Trap is
turned to hold the Cable in the groove of the
Pulley.
68. Remove the indicated 90mm Pulley (78) from the
Long Base (120). Wrap the Lat Cable (88) under
the Pulley. Reattach the Pulley to the Base with
the M10 x 95mm Bolt (92) and the M10 Nylon
Locknut (87).
69. Wrap the Fly Cable (85) over a 90mm Pulley (78).
Attach the Pulley and a Cable Trap (68) between
the second set of holes from the bottom of the
indicated pair of Pulley Plates (63) with an M10 x
50mm Bolt (100) and an M10 Nylon Locknut (87).
Make sure that the Cable Trap is turned to
hold the Cable in the groove of the Pulley.
70. Attach the Fly Cable (85) inside the Long Base
(120) with an M10 x 65mm Bolt (18), two M10
Washers (91), and an M10 Nylon Locknut (87).
67. Wrap the Fly Cable (85) under a 90mm Pulley
(78). Attach the Pulley to the indicated bracket on
the Short Base (2) with an M10 x 45mm Bolt (93)
and an M10 Nylon Locknut (87).
66
67
68
69
70
87
91
18
120
85
100
68
85
63
87
78
92
120
87 78
87
93
2
78
85
59
85
87
68
100
78
91
88