Gold's Gym XRT 75 GGSY69320 - Manual (Page 18)

18
41. Wrap the Butterfly Cable (69) under a 90mm
Pulley (78). Attach the Pulley to the Double “U”-
bracket (62) with an M10 x 45mm Bolt (93) and
an M10 Nylon Locknut (87).
43. Lubricate an M10 x 50mm Bolt (100) with grease.
Attach a Pivot Bracket (70) to the Right Butterfly
Arm (26) with the Bolt and an M10 Nylon Locknut
(87). Do not overtighten the Locknut; the Pivot
Bracket must be able to pivot easily.
Attach the Butterfly Cable (69) to the Pivot
Bracket (70) with an M8 x 20mm Shoulder Bolt
(103) and an M8 Nylon Locknut (71). Do not
overtighten the Locknut; the Cable must be
able to pivot easily.
44. Locate the Leg Lever Cable (75). Route the
eyelet end of the Cable through the Seat Leg (9)
and attach it to the tab on the Leg Lever (10) with
an M8 x 20mm Shoulder Bolt (103) and an M8
Nylon Locknut (71). Do not overtighten the
Locknut; the Cable must be able to pivot easi-
ly.
45. Attach a 90mm Pulley (78) inside of the Seat Leg
(9) with an M10 x 65mm Bolt (18), two M10
Washers (91), two 12.5mm Spacers (89), and an
M10 Nylon Locknut (87). Make sure the Pulley
is above the Leg Lever Cable (75).
42. Wrap the Butterfly Cable (69) over a “V”-pulley
(55). Attach the “V”-pulley and a Long Cable Trap
(102) to the Butterfly Upright (3) with an M10 x
57mm Bolt (98) and an M10 Nylon Locknut (87).
Make sure the Cable Trap is turned to hold the
Cable in the groove of the Pulley.
41
42
43
44
45
69
87
87
103
102
78
55
3
70
71
93
69
87
69
98
62
100 103
75
75 78
26
89
89
Lubricate
9
10
91
91
18
9
71
87