Gold's Gym XRT 75 GGSY69320 - Manual (Page 16)

32. Wrap the Dip Cable (74) over a 90mm Pulley
(78). Attach the Pulley to the second bracket on
the right side of the Butterfly Top Frame (7) with
an M10 x 45mm Bolt (93) and an M10 Nylon
Locknut (87).
33. Attach the Dip Cable (74) to a Small “U”-bracket
(106) with an M8 Washer (90) and an M8 Nylon
Locknut (71). Do not completely tighten the
Locknut; it should be tightened so that only
two threads of the Cable show past the
Locknut, as shown in the inset drawing.
Attach the Small “U”-bracket (106) to the Long
Weight Tube (43) with an M8 x 45mm Bolt (108)
and an M8 Nylon Locknut (71). Do not overtight-
en the Locknut; the Weight Tube must be able
to pivot in the “U”-bracket.
32
33
74
74
90
71
43
106
108
71
78
93
7
87
16
34. Locate the Squat Cable (73). Attach the Cable
and two 30mm Spacers (124) between the brack-
ets on the Squat Slider (38) with an M10 x 85mm
Bolt (96) and an M10 Nylon Locknut (87). Do not
overtighten the Locknut; the Rollers (not
shown) in the Squat Slider must be able to roll
easily.
35. Wrap the Squat Cable (73) under a 90mm Pulley
(78). Attach the Pulley and a Cable Trap (68) to
the indicated bracket on the Long Base (120) with
an M10 x 50mm Bolt (100) and an M10 Nylon
Locknut (87). Make sure the Cable Trap is ori-
ented to hold the Cable in the groove of the
Pulley.
34
35
73
96
78
73
100
124
38
68
120
87
87
71
74