Installing your freezer (cont.) – Grindmaster 3341A User Manual
Page 8
Page 6
Crathco
®
Remote Beverage Freezers
Installing Your Freezer (cont.)
7. Review hopper contents to make sure all parts are available:
*Optional items specified when the unit is ordered.
8. Fill out Warranty Registration Card with the requested information and mail to Grindmaster Corporation.
9. Replace side panels.
10. Assemble the dispense valve following the instructions on page 9. The valve plunger, spring and retaining pin
come in the small parts bag.
11. Be sure ON-OFF-CLEAN switch (toggle switch located underneath the electrical box) is in the “OFF” position.
12. Connect the power cord directly to a properly grounded DEDICATED 120V/60Hz, 15 Amp circuit.
Do not use an extension cord.
CAUTION: Do not alter or deform the plug in any way! Altering or deforming the plug may damage
unit and will void warranty.
13. Remove the drip tray kit from the bubble wrap. Separate the parts and remove the protective coating. The drip
tray is mounted on two screws that are located on the lower front of the freezer cabinet.
14. Place the key hole slot of the drip tray support bracket on to these screws and tighten the screws.
15. Angle the back of the drip tray surround bracket into the drip tray support bracket and lower bracket
to lock it into place.
16. Place drip tray onto drip tray surround bracket.
17. Place the louvered drip tray insert into drip tray.
18. A private label or different drink header can be installed by removing
two screws from the electrical box cover. Carefully remove electrical box
cover. Place the header (transparency) between the clear and opaque
plates (plastic lens). Put these in place under the lip of the machine top.
Slip the electrical box cover back on to machine and reinsert the
screws. (see Figure F)
Part #
Description
W0600224
Manual
W0600073
Rubber Pad Sheet
W0600121
Merchandiser Installation Sheet
W0600012
MSDS Sanitizer Sheet
W0600159
Warranty Registration Card
*
Drip Tray Kit
*
Hopper Cover
W0480445
Valve Handle
W0631230
Valve Spring
*
Carb Tube
*
Dispense Valve Plunger
W0470076
Lubricant
W0631903
Sanitizer Packets
W0600058
Laminated Cleaning Card
W0600327
Seal Installation Instructions
W0890220
4” Leg Set
ƽ
Figure F