GE QS24 UR - Manual (Page 55)

QUICKSTART GUIDE
UR SWITCH MODULE – QUICKSTART GUIDE QS–51
QS.6 UR Switch Module Firmware Updates
QS.6.1 Updating UR Switch Module Firmware
This section describes the process for upgrading firmware on a UR-2S/T Switch Module.
There are several ways of updating Firmware on a UR Switch Module: EnerVista UR Setup
software, Serial using the UR Switch Module’s Console port, tftp or through ftp. It’s highly
recommended to use EnerVista UR Setup software to upgrade Firmware on a UR Switch
Module.
NOTE
Note Firmware upgrade using serial, TFTP, and FTP, are described in the UR Switch Module
manual.
QS.6.2 Selecting the Proper Version
The latest version of the firmware is available as a download from the GE Multilin web site.
To determine the version of firmware currently installed on your Switch, proceed as
follows:
Z Using the EnerVista web interface, log into the Switch using the
procedure described earlier. The firmware version installed on the
switch will appear on the lower left corner of the screen.
Z Using the EnerVista UR Setup program, select Settings > Product
Setup > Communications > Ethernet Switch > Firmware Upload.
The following popup screen will appear warning that the settings
will be lost when the firmware is upgraded.
Version: 2.1beta