Gold's Gym GGCCBE8057.0 - Manual (Page 8)

8
3. Attach the Front Leg (3) to the Bench Frame (1)
with two M10 x 100mm Screws (117) and two
M10 Washers (148).
Tighten the Screws used in
steps 1 and 3.
4. Attach the Backrest (32) and the Headrest (99) to
the Backrest Frame (8) with six M6 x 20mm
Screws (122).
3
1
3
148
117
4
122
99
122
122
8
32
5. Attach the Backrest Support Spacer (51) between
the two Backrest Supports (7) with an M10 x
165mm Bolt (123), two M10 Washers (148), and
an M10 Nylon Locknut (153).
Do not tighten the
Nylon Locknut yet.
Orient the Backrest Supports (7) so that the
Backrest Support Spacer (51) is closer to the
upper ends.
Apply some of the included grease to an M10 x
165mm Bolt (123). Attach the Backrest Frame (8)
and two Backrest Bushings (48) between the
Backrest Supports with the Bolt, two M10
Washers (148), and an M10 Nylon Locknut (153).
Do not overtighten the Nylon Locknut; the
Backrest Supports must pivot easily.
5
148
148
148 153
153
148
123
123
Upper
Ends
48
51
48
7
7
8
Grease
Opening
Opening