GE 45130 User Manual

Page 9

Learn button on the Control Center. The unit will

beep once.
Step 2 -

While holding the Learn button, press and

hold the Zone button to be erased. After five

seconds the Control Center will sound two beeps

and the Zone LED indicator will flash twice.
Step 3 - Release all buttons. The Zone has

been erased.

Note: The Zone/Garage Door Sensor cannot be erased if:
- The Zone has been triggered for an Alert or alarm. The
Sensor/Zone must be reset.
- There is loss of signal from the Sensor to the Control
Center (such as low battery, or Sensor is out of range).
- The system is armed.
The Control Center will sound three beeps to indicate it could
not erase the Zone.

Testing a Sensor or your system
Once all the Sensors have been assigned to Zones

in the Control Center you can now test your system.

Ensure the Control Center can receive the signal

from the intended location of the Sensor before

permanently mounting a Sensor.

Step 1 - To place Control Center in Test mode

unplug AC adapter and remove batteries.
Step - Press and hold the ‘Mute’ button and plug

the AC adapter back into the Control Center. When

all the LED indicators turn on, release the Mute

button. The Control Center is now in Test Mode and

any Sensor can now be tested in any Zone.
Step - Set the Notification Mode to switch ‘Alert’
position and begin activating Sensors one at a time.

1 2 3 4

Arm

Zone

Armed Power

Alert

Chime

Off

Mute

Learn

Input DC 12V

Add a Sensor

Step 1
Press and hold
the Learn button
for three seconds

Step 3
Release the
Zone button
Step 4
Activate the Garage
Door Sensor

Step 2
Select the Zone number