Step 1 - to erase a zone, press and hold the – GE 45130 User Manual

Page 8

Follow these steps to assign a Sensor to a Zone.
Step 1 – Press and hold the Learn button on the

Control Center for three seconds. When the

Control Center sounds a long beep, release the

Learn button.
Step 2 – Press the Zone button (1, 2, 3 or 4) for the

Zone you want to assign to the Garage Door Sensor.

The LED indicator for that Zone will begin to flash.
Step 3 –

Release the Zone button.

Note: Zone 4 is for dedicated alerts only. Sensors in this Zone

will not trigger an alarm or chime.

Step 4 – Activate the Garage Door Sensor
- To activate The Garage Door Sensor, lower
the detection rod to its full extension; if mounted,

raise the garage door.

Erasing the Sensor from a Zone

Note: If you need to remove the Sensor from a Zone, the
system will erase the entire Zone, so any other Sensors will
need to be put back into that particular Zone.

Step 1 - To erase a Zone, press and hold the

1 2 3 4

Arm

Zone

Armed Power

Alert

Chime

Off

Mute

Learn

Input DC 12V

Add a Sensor

Step 1
Press and hold
the Learn button
for three seconds

Step 3
Release the
Zone button
Step 4
Activate the Garage
Door Sensor

Step 2
Select the Zone number