GTO SL-1000B - Manual (Page 9)

7
IMPORTANT SAFETY INSTRUCTIONS
These warning labels should be found at the locations specified below. If any of them are missing, immediately
contact your installer for replacements.
WARNING
!
• Fingers, hands, and
loose clothing may be
dragged into chain
sprockets.
• Fingers and hands can
be injured by rotating
sprockets.
• Keep hands, fingers,
and loose clothing
away from chain and
chain opening in
operator housing.
• Fingers, hands, and loose clothing
may be dragged into chain sprockets.
• Fingers and hands can be injured by
rotating sprockets.
• Keep hands, fingers, and loose clothing
away from chain and sprockets.
WARNING !
warning labels (3). Located on both sides and back
of operator housing
warning label located on top
of control box
• Moving parts inside are capable of
causing injury to fingers and hands.
• DO NOT remove operator housing.
• Consult your safety manual before
making adjustments.
• For service, call an experienced technician.
AUTOMATIC GATE OPENERS 1-800-543-GATE
WARNING
!
warning label located on front of operator housing
product identification and manual operation instruction
label installed on control box cover
RB2002
Maximum Gate: 1000 lb. (453.4 kg); 30 ft. (9.1 m)
Voltage: 12 Vdc; Frequency: 0 Hz; Power: 93.2 W
Class I, II and III Vehicular Slide Gate Operator
Serial Number:
SL2000-xxxxxxx
9901178
Conforms to UL 325 STANDARDS
Certified to CAN/CSA-C22.2 No.247-92
Disconnect operator ONLY when the gate is NOT moving.
TO MANUALLY OPEN AND CLOSE THE GATE:
1. Lift quick release pins UP, then pull them OUT of chain brackets.
2. Lay chain down and manually slide gate to desired position.
Series
GTO, Inc. Tallahassee, Florida USA
LISTED
US C
RB2001
Maximum Gate: 500 lb. (226.7 kg); 30 ft. (9.1 m)
Voltage: 12 Vdc; Frequency: 0 Hz; Power: 93.2 W
Class I, II and III Vehicular Slide Gate Operator
Serial Number:
SL1000-xxxxxxx
9901178
Disconnect operator ONLY when the gate is NOT moving.
TO MANUALLY OPEN AND CLOSE THE GATE:
1. Lift quick release pins UP, then pull them OUT of chain brackets.
2. Lay chain down and manually slide gate to desired position.
Series
GTO, Inc. Tallahassee, Florida USA
SL
LISTED
US C
Conforms to UL 325 STANDARDS
Certified to CAN/CSA-C22.2 No.247-92