Grizzly 12" Jointer w/spiral cutterhead manual insert g0609X - Manual (Page 27)

-12-
G0609 12" Parallelogram Jointer
Inventory
After all the parts have been removed from the
wood crate, you should have the following items:
Crate Contents: (Figure 3 & 4) Qty
A. Jointer Assembly ........................................ 1
B. Fence Assembly ......................................... 1
C. Fence Bracket ............................................ 1
D. Push Blocks ................................................ 2
E. Knife Setting Jig ......................................... 1
Figure 3. Crate contents.
In the event that any nonproprietary parts are
missing (e.g. a nut or a washer), we would be
glad to replace them, or for the sake of expedi-
ency, replacements can be obtained at your local
hardware store.
Figure 4. Additional crate contents.
A
B
C
D
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed on the machine.
Check these locations before assuming that
any items from the inventory list are miss-
ing.
Hardware and Tools Qty
• Hex Wrenches 3, 4, 8, 10mm ...........1 Each
• Open End Wrench
10/12, 12/14,17/19mm ......................1 Each
• Cap Screws M12-1.75 x 30 (Fence) .......... 2
• Flat Washers 12mm (Fence) ...................... 3
• Lock Washers 12mm (Fence) .................... 2
• Lock Nut M12-1.75 (Fence) ....................... 1
• Flat Washers 10mm (Pedestal) .................. 2
• Lock Washers 10mm (Pedestal) ................ 2
• Cap Screws M10-1.5 x 25 (Pedestal) ........ 2
SUFFOCATION HAZARD!
Immediately discard all plas-
tic bags and packing materi-
als to eliminate choking/suf-
focation hazards for children
and animals.
E