GE EER4001 - Manual (Page 25)

Safety Instructions
Operating Instructions
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
25
ge.com
Oven Heating Elements
Do not clean the bake element or the broil
element. Any soil will burn off when the
elements are heated. To clean the oven floor, gently lift
the bake element. Clean with warm
soapy water.
Oven Shelves
All oven shelves may be cleaned by hand
with an abrasive cleaner or steel wool.
After cleaning, rinse the shelves with
clean water and dry with a clean cloth.
Gray porcelain-coated oven shelves may
remain in the oven during the self-
cleaning cycle without being damaged.
The shiny, silver-colored oven shelves
may remain in the oven during the self-
cleaning cycle, but they will lose their
luster and become hard to slide. It will be necessary to grease all oven
shelf side edges with a light coating of
vegetable oil after cleaning them by hand
or in the oven. This will help maintain
the ease of sliding the shelves in and
out of the oven.
Storage Drawer Removal
To remove the drawer:
Pull the drawer out until it stops.
Lift the front of the drawer until the
stops clear the guides.
Remove the drawer.
To replace the drawer:
Place the drawer rails on the guides.
Push the drawer back until it stops.
Lift the front of the drawer and push
back until the stops clear the guides.
Lower the front of the drawer and
push back until it closes.
Stop guide Rail
Oven Light Replacement
CAUTION: Before replacing your oven
light bulb, disconnect the electrical
power to the range at the main fuse or
circuit breaker panel.
Be sure to let the light cover and bulb
cool completely.
To remove the cover:
Hold a hand under the cover so it
doesn’t fall when released. With
fingers of the same hand, firmly
push back the wire cover holder.
Lift off the cover.
Do not remove any screws to remove the cover.
Replace bulb with a 40-watt
appliance bulb.
To replace the cover:
Place it into groove of the light
receptacle. Pull wire forward to
the center of the cover until it
snaps into place.
Connect electrical power to
the range.
Wire cover holder.