Gateway ProfileTM 5 - Manual (Page 27)

19
Using the cord cover
www.gateway.com
Using the cord cover
After you have the power and peripheral device cords connected to your
computer, install the cord cover to make your computer look less cluttered.
To install the cord cover:
■ Align the tabs on the top of the cover with the slots above the back ports,
then swing the cord cover’s bottom tabs into the slots on the bottom of
the computer (view shown from below for clarity).
To remove the cord cover:
■ Press the cord cover’s bottom tabs inward, then rotate the cord cover away
from the computer.
Tips & Tricks If you have difficulty sliding the cover’s bottom tabs into
the computer slots, press the bottom corners of the cord
cover inward while pressing the cord cover into place.