GarrettCom CS14 - Manual (Page 62)

CS14 & CSN14 Series Converter Switches Installation and User Guide (09/09)
53
www GarrettCom com . .
When an RJ-45 cable connection is made, and each time LINK is enabled, auto-
negotiation takes place (except for legacy products, which do not have auto-negotiation and
which go to the default state accordingly). The Magnum Switch advertises its capability for
10 or 100 Mbps speed and F/H duplex mode, and the device at the other end of the cable
should similarly advertise / respond. Both sides will agree to the speed and mode to be used
per the IEEE 802.3u standard. Depending upon the devices connected, this will result in
agreement to operate at either 10 Mbps or 100Mbps speed, and full- or half-duplex mode.
4.3 (F-H) Switch, Full-Duplex or Half-Duplex for Fiber port# 1
The (F–H) manual switch has been provided for fiber port #1, for fixing that port
at Full or Half Duplex as per the requirements. The (F-H) manual switch is being located
underneath the fiber port. The Fiber port with 10Mb is being set at Half-Duplex, and the
100Mb being set at Full-Duplex as default from the factory. The port can be set at the
required mode, by sliding the manual switch position to “F” or “H”.