Grizzly G0710 - Manual (Page 17)

Model g0710/g0710p (Mfg. since 11/11)
-15-
assembly
— if mounting to a wood framed wall (with
or without drywall), the bracket must be
mounted directly to a support board that
is wide enough to span and mount onto
two wall studs. Mount the support to the
wall studs with lag screws, then mount the
bracket to the support with appropriate fas-
teners, as shown in
figure 10.
For adequate motor cooling, the motor fan intake
must not be restricted by a wall or cabinet.
to assemble and mount the dust collector:
1. Fasten the motor bracket to the motor base
with the four included flange bolts, and install
the adhesive foam strip on the dust collector
outlet port at the location shown in
figure 8.
figure 9. Wall mounting bracket positioning.
LVaa
LVaa
;addg
Note:Drawing
Not to Scale.
) & $
'
B^c^bjb
)'
B^c^bjb
2. using the wall mounting bracket as a tem-
plate, mark the mounting hole location so
the bottom of the mounting bracket is a mini-
umum of 42" from the floor and at least 4
1 ⁄
2
"
away from any wall, as shown in figure 9.
LVaa
Bdjci^c\
7gVX`Zi
Bdidg7gVX`Zi
;aVc\Z7dai
6Y]Zh^kZ;dVbHig^e
7V\8aVbe
figure 8. dust collector assembly diagram.
LVaaHijY
Hjeedgi
7dVgY
LVaa
Bdjci^c\
7gVX`Zi
AV\7dai
figure 10. Mounting bracket secured to support
board on wall studs.
3. after the mounting bracket is installed on the
wall, have another person help you hang the
dust collector on the bracket.
4. install the dust collection bag with the bag
clamp (see figure 8), then connect the duct-
ing. refer to collection system on the next
page for grounding requirements.
figure 11. typical fasteners for mounting dust
collector bracket to masonry or concrete walls.
anchor stud
lag shield anchor
and lag screw
— if mounting to a concrete or masonry wall,
attach the bracket using lag shield anchors
with lag screws or anchor studs (see
figure 11).