Stovax Huntingdon 30 - Manual (Page 7)

7
7.1 Ensure the rope seal fitted to the rear of the glass frame is
intact.
• Use a ceramic glass product generally sold for cleaning
ceramic hobs to clean the glass front
• Refit glass frame and tighten screws evenly, Diagram 12
With the top still supported or removed:
• Refit front by locating in grooves and lowering into
place, Diagram 13
• Now replace top, Diagram 14
8.1 The stove is fitted with the Gazco Flue Sure System, which
will act to cut off the gas supply to the burners in the event
of incorrect operation of the flue. If the system acts to cut
off the gas supply, this indicates that there is insufficient flue
pull. If this occurs a minimum of 10 minutes should be
allowed before trying to relight. Continued operation of this
safety device means there may be a serious problem with
the flue system. A qualified gas engineer should inspect this.
Do not use the stove until an engineer says it is safe to
do so.
9.1 This is a safety feature incorporated in all GAZCO fires,
which automatically switches off the gas supply if the pilot
light goes out and fails to heat the thermocouple.
10.1 The surface coating on your GAZCO stove will ‘burn off’
during the first 24 hours of operation on high, producing a
harmless and temporary odour. If the odour persists ask
your retail for advice.
11.1 A qualified gas engineer must service the stove every 12
months. In all correspondence, always quote the appliance
type and the serial number that may be found on the data
badge on the appliance.
12.1 Any purpose provided ventilation should be checked
periodically to ensure that it is free from obstruction.
13.1 To assist in any future correspondence, your installer should
have completed this commissioning sheet, this records the
essential installation details of this appliance. In all
correspondence always quote the model No. and serial No.
14.1 Parts of this appliance become hot during normal use. It is
therefore recommended that a suitable fire guard be used
for protection of young children and the infirm. Indeed, all
parts of the appliance should be treated as a 'working
surface' except for the control touch pad area and access
panel.
14. HOT SURFACES
13. INSTALLATION DETAILS
12. VENTILATION
11. SERVICING
10. 'RUNNING IN'
9. THE FLAME FAILURE DEVICE
8. GAZCO FLUE SURE SYSTEM
14
AR1907
13
AR1908
12
AR1909
7. REPLACING THE DOOR
AR0364
11
USER INSTRUCTIONS