Stovax Huntingdon 30 - Manual (Page 17)

17
2.4 Remove the two screws at the back of the firebox and lift
the burner unit clear Diagram 3
3.1 • Follow the procedure for removing the main burner
When the burner is out:
• Remove the aeration cover by undoing the two screws,
Diagram 4
• Remove the lint arrester, by folding the tabs back
Diagram 5
AR1444
5
AR1443
4
AR1442
3
1.1 All principal components can be replaced without removing
the stove from its installation, although it is essential that the
gas supply to the appliance is turned off at the isolation
device before proceeding further.
2.1 MAKE SURE THE APPLIANCE IS COLD BEFORE
STARTING WORK ON IT!
•
Turn the gas supply off at the isolation device:
- Use Installation Section, Removing the Door, in the
this manual.
• Remove the door and place to one side
• Remove the ceramic fuel bed components.
For information on the handling and disposal of fire
ceramics please refer to the User Instructions, Fuelbed
Arrangements.
• Remove the cover plate from the bottom of the stove by
undoing the mounting screws on the plate and place to one
side, Diagram 1
2.2 Refering to Diagram 2:
• Disconnect the thermocouple from the gas valve (A)
• Remove the ignition lead from the electrode (B)
• Cut the cable tie if required
• Undo the compression nut (C) from the pilot unit and
undo the compression nut on the injector (D).
AR1441
D
C
A
B
2
AR1924
1
2. MAIN BURNER
1. GENERAL
SERVICING INSTRUCTIONS
REPLACING PARTS
3. PILOT UNIT