Stovax Huntingdon 30 - Manual (Page 4)

1.1 A competent person must carry out installation and
servicing.
1.2 In all correspondence, please quote the appliance type and
serial number, which can be found on the databadge
located on a plate under the appliance.
1.3 Ensure that curtains are not positioned above the appliance
and there is at least 300mm between the sides of the
appliance and any curtains.
1.4 If any cracks appear in the glass panel do not use the
appliance until the panel has been replaced.
1.5 This product is guaranteed for 2 years from the date of
installation, as set out in the terms and conditions of sale
between Gazco and your local Gazco dealer. Please consult
with your local Gazco dealer if you have any questions. In
all correspondence always quote the Model Number and
Serial Number.
1.6 Any combustible shelves or surrounding furniture must only
be fitted in accordance with the minimum dimensions
detailed in diagram 1.
1.7 Contact a competent service engineer to carry out relevant
spillage checks etc. following home improvements carried
out after installation of this stove (e.g. the fitting of double
glazing).
2.1 The control valve is at the foot on the right-hand side of the
fire. It has two controls:
• The right-hand knob controls the pilot ignition
• The left-hand knob controls the main burner
2.2 Refer to separate instructions if your fire is upgraded to
include battery remote control. The instructions below
apply whether or not you have the remote upgrade.
2. LIGHTING THE STOVE
AR0552
150
225
150
853
1
1. GENERAL
Lighting the Pilot
2.3
The left-hand and right-hand control knobs must both point
to off ( ):
• Press in the right-hand control knob and rotate anti-
clockwise until a click is heard
• Continue to press in. The knob points to the pilot ( ).
The pilot is lit
• Keep the knob depressed for 10 seconds before
releasing. The pilot remains lit.
• Repeat the above steps if the pilot does not stay lit
NOTE: If the pilot goes out, the Interlock system prevents you
lighting again for a short period
2.4 If, after repeating the above steps the pilot does not light,
contact your Retailer or Installer.
2.5 Turn the right-hand knob to the left to main burner ( )
Adjusting the Flame height
2.6
You can now adjust the flame height and temperature using
the left-hand control knob:
• Turn the left-hand knob anti-clockwise to increase the
flame height
• Turn clockwise to decrease the height
YELLOW FLAMES APPEAR WHEN THE FIRE HAS
REACHED SUFFICIENT HEAT – (10 TO 20 MINUTES).
IF THE FIRE IS EXTINGUISHED OR GOES OUT IN USE,
WAIT 3 MINUTES BEFORE TRYING TO RELIGHT.
MINUTES.
3.1 To turn the main burner out:
• Turn the left-hand knob until it points to off ( ).Just the
pilot remains lit.
• Press in and turn the right-hand knob until it points to
off ( ). The pilot goes out.
4.1 Your stove is fitted with a control valve that can easily be
upgraded to battery powered remote control. This upgrade
can be fitted by anyone capable of simple DIY jobs and
requires no special training. There are two versions of this
control which can be obtained through your local Gazco
stockist.
4. UPGRADING YOUR STOVE
3. TURNING THE STOVE OFF
AR0914
2
4
USER INSTRUCTIONS