User instructions, Cleaning the fire – Stovax Huntingdon 30 User Manual
Page 5
5
4.2
STANDARD REMOTE CONTROL This remote control can
control the gas appliance after the pilot has been lit. It can
turn the main burner on and regulate it from low through to
high and back again. It can turn the main burner off leaving
the pilot burning GAZCO PART NUMBER 8455.
4.3
THERMOSTATIC AND TIMER REMOTE CONTROL This
remote control can control the gas appliance after the pilot
has been lit. In ‘MANUAL MODE’ it can be used to turn the
main burner on and manually regulate it from low through
to high and back again. It can also be used to turn the main
burner leaving the pilot burning. In ‘AUTO MODE’ it will
automatically regulate the room temperature to a pre-set
temperature. In ‘TIMER MODE’ it will turn the fire on and
off according to a pre-set programme and automatically
regulate the room temperature during the two on periods.
GAZCO PART NUMBER 8456
5.1
Make sure the fire and surrounds are cool before trying to
clean.
5.2 REMOVING THE DOOR
For rear flue exit:
• Lift the top of the appliance off and put to one side.
For top flue exit:
• Lift and support the top to give clearance, Diagram 3
• Lift the front upwards until it is clear of the slots
• Pull towards you away from the stove, Diagram 4
3
AR1907
WARNING: NEVER CLEAN THE STOVE WHILE IT’S HOT.
THE STOVE STAYS HOT FOR A LONG TIME AFTER
SHUTDOWN.
5.CLEANING THE FIRE
• Remove the glass frame by undoing the frame fixing
screws and lifting clear, Diagram 5
5.3
Carefully remove the ceramic fuel bed components and set
aside, ensuring you protect the floor coverings and follow
the Advice given at the start of Section 6.
5.4
The coals do not require cleaning. Do not use a vacuum
cleaner or brush to clean the coals, any large pieces of
debris can be removed by hand.
5.5
Ensure any debris is removed from the burner ports.
5.6
Replace the ceramics by referring to Section 6.
5.7
Use a damp cloth to clean the outer casing of the
appliance.
5
AR1909
4
AR1908
USER INSTRUCTIONS