Gefen EXT-COMPAUD-CAT5-444 - Manual (Page 8)

5
1 Power LED Indicator
This LED will become active once the included 24V DC power adapter is
properly connected.
2 Output 1 Source LED Indicator
The currently selected source being displayed on Monitor Output 1 will be
visually acknowledged by an active LED. There are 4 LED’s, one for each input
source.
3 Output 2 Source LED Indicator
The currently selected source being displayed on Monitor Output 2 will be
visually acknowledged by an active LED. There are 4 LED’s, one for each input
source.
4 Output 3 Source LED Indicator
The currently selected source being displayed on Monitor Output 3 will be
visually acknowledged by an active LED. There are 4 LED’s, one for each input
source.
5 Output 4 Source LED Indicator
The currently selected source being displayed on Monitor Output 4 will be
visually acknowledged by an active LED. There are 4 LED’s, one for each input
source.
6 IR Receiver
This port will receive IR commands from the included RMT-16IR remote control.
7 Power Button
Pressing this button while the unit is on will place the unit in stand-by mode.
Pressing this button again while the unit is in stand-by will turn it on.
8 Output 1 Source Button
Each press of this button will cycle through the 4 inputs which will be displayed
on the Monitor Output 1.
9 Output 2 Source Button
Each press of this button will cycle through the 4 inputs which will be displayed
on the Monitor Output 2.
10 Output 3 Source Button
Each press of this button will cycle through the 4 inputs which will be displayed
on the Monitor Output 3.
11 Output 4 Source Button
Each press of this button will cycle through the 4 inputs which will be displayed
on the Monitor Output 4.
4X4 COMPONENT MATRIX OVER CAT-5 FRONT
PANEL DESCRIPTIONS