Install tip and guard – Graco MAGNUM 261800 User Manual

Page 13

Getting Started

312079A

d. set AllControl to

PRIME/CLEAN GUN &
HOSE.

11. Continue to trigger into waste pail until you see

only paint coming out of gun.

12. Release trigger. Engage

trigger lock.

13. Transfer drain tube to paint pail and clip prime

tube to suction tube.

14. If spraying, install tip and guard on gun, page

13 and see Spraying Techniques, page 14.

If rolling, roller setup and Rolling Techniques,
begin on page 18.

Install Tip and Guard

1. Engage trigger lock.

2. Verify tip and guard parts are assembled in

order as shown below.

3. Screw tip and guard assem-

bly on gun. Tighten retaining
nut.

• Motor stopping indicates pump and hose

are primed with paint.

• If motor continues to run the sprayer is

not properly primed. To reprime repeat
step 6.

ti9171a

ti8923a

retaining nut

black rubber gasket and

guard

tip

ti8911a

metal seat

TIA

Use tip to align seat

in guard

Tip must be pushed
all the way into guard

ti9574a

ti9255a