Gateway GT5448E - Manual (Page 46)

CHAPTER 4: Upgrading Your Computer
40
5 Slide the new card reader into the bay from the front
of the case.
6 Use the screws you removed previously to secure the
card reader to the bay.
7 Connect the new card reader’s data cable to the system
board.
8 Reinstall the bezel by following the instructions in
“Replacing the front bezel” on page 32 .
9 Reinstall the computer case’s side panel by following
the instructions in
“Replacing the side panel” on
page 33 .
Adding or replacing a hard
drive
To add or replace a hard drive:
1 Remove the side panel by following the instructions in
“Removing the side panel” on page 31 .
2 If you are adding a new drive, go to Step 4 . If you are
replacing an existing drive, go to the next step.
Tools
You need a Phillips screwdriver to add or replace a hard drive.
Screws
8511861.book Page 40 Monday, December 18, 2006 11:20 AM