Gateway GT5448E - Manual (Page 43)

www.gateway.com
37
Adding or replacing a CD or
DVD drive
To add replace a CD or DVD drive:
1 Remove the side panel by following the instructions in
“Removing the side panel” on page 31 .
2 Remove the front bezel by following the instructions in
“Removing the front bezel” on page 32 .
3 If you are installing a new drive (not replacing an old
one), remove the two drive retention screws in the drive
bay, then go to
Step 7 . For the location of the screws,
see the photo in Step 6 .
4 If you are replacing an existing drive, disconnect the
cables from the drive, noting their locations and
orientation. You will reconnect the cables after you
install the new drive. (CD/DVD drive shown.)
5 Note any jumper settings on the old drive and set the
jumper on the new drive to be the same.
Tools
You need a Phillips screwdriver to add or replace a CD or DVD drive.
Important
The color and shape of your replacement drive’s front cover may
vary from your original drive.
8511861.book Page 37 Monday, December 18, 2006 11:20 AM