GSI Outdoors PNEG-1153 - Manual (Page 8)

8 PNEG-1153 CALC-U-DRI Moisture/Matic/Manager
4. INSTALLATION
Sensor Cutout Instructions
Sensor Cut-Out Instructions for Six (6)" and Eight (8)" Augers
DISCONNECT POWER TO THE AUGER MOTOR BEFORE PROCEEDING ANY FURTHER!
1. Look at the discharge tube and determine where the sensor can be located.
(See Figure 4C). There must be at least one (1) full pitch of flighting on the discharge auger
before and after the sensor to move the grain over the sensor blade.
Note: If the unit has a connecting band, determine if it can be removed and replaced with
a 12" long connecting band. If it is a structural supporting connecting band,
additional support may be needed during removal of the connecting band.
Figure 4B
Figure 4C
CAUTION