GE JT91530 - Manual (Page 23)

Do not use a steel-wool pad; it will
scratch the surface.
To clean the stainless steel surface,
use warm sudsy water, a stainless steel
cleaner such as Kleen King
® or an
all-purpose liquid or spray cleaner.
Always scrub in the direction of the
grain. Rinse thoroughly with a sponge
or cloth and clean water. Dry with a soft,
clean cloth.
After cleaning, use a stainless steel
polish, such as Stainless Steel Magic
® ,
Revere Copper and Stainless Steel
Cleaner
® or Wenol All Purpose
Metal Polish ® . Follow the product
instructions for cleaning the stainless
steel surface.
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
23
Care and cleaning of the oven.
www.GEAppliances.com
Be sure electrical power is off and all surfaces are cool before cleaning any part of the oven.
How to Remove Packaging Tape
To assure no damage is done to the finish
of the product, the safest way to remove
the adhesive left from packaging tape
on new appliances is an application
of a household liquid dishwashing
detergent, mineral oil or cooking oil. Apply with a soft cloth and allow to soak.
Wipe dry and then apply an appliance
polish to thoroughly clean and protect
the surface.
NOTE: The plastic tape must be removed from all
chrome trim. It cannot be removed if it is baked on.
Oven Light Bulbs
NOTE: The glass cover should be
removed only when cold. Wearing latex
gloves may offer a better grip.
CAUTION
: Before replacing your
oven light bulb, disconnect the electrical
power to the oven at the main fuse or
circuit breaker panel.
Be sure to let the light cover and bulb
cool completely.
For your safety, do not touch a hot bulb
with bare hands or a damp cloth.
To remove:
Turn the glass cover
counterclockwise 1/4 turn until the
tabs of the glass cover clear the
grooves of the socket.
Using gloves or a dry cloth, remove
the bulb by pulling it straight out.
To replace:
Use a new 130-volt Halogen bulb,
not to exceed 50 watts.
Using gloves or a dry cloth, remove
the bulb from its packaging. Do not
touch the bulb with bare fingers.
Push the bulb straight into the
receptacle all the way.
Place the tabs of the glass cover into
the grooves of the socket. Turn the
glass cover clockwise 1/4 turn.
For improved lighting inside the
oven, clean the glass cover
frequently using a wet cloth. This
should be done when the oven is
completely cool.
Reconnect electrical power to
the oven.
Bulb
Socket
Tab
Glass cover
Receptacle
Use gloves
or cloth
Receptacle
Stainless Steel Surfaces (on some models)