GE 45631 GE Z-Wave Wireless Keypad Controller - Manual (Page 9)

Please Note: Z-Wave home control networks are designed to work
properly alongside 802.11 wireless computer networks, Bluetooth
and other 2.4GHz or 5.8GHz devices. Some baby cams, wireless video
devices and older cordless phones using the 900MHz frequency range
may cause interference and limit Z-Wave functionality. Many 900MHz
products have a switch to select channel “A” or “B”. You may find that
one of these channels will cause less interference than the other.
Mounting
1. We recommend that you setup the controller and familiarize
yourself with the functions before mounting it. This controller
may be mounted with double sided tape or screws (and
hollow wall anchors where necessary). Mounting hardware is
included. The mounting surface must be smooth and clean
if using the tape. Ideally, it should be mounted at the same
height as the wall switches in your home.
2. The faceplate snaps onto the main body of the controller after
it is mounted on the wall. It can be easily removed by inserting
a small flat blade screwdriver into the slot on the bottom and
twisting gently.
Operation
NOTE: In order to prolong battery life, the controller will “Time-
Out”, exit setup and go into stand-by (sleep) mode if more than 10
seconds elapses between steps in any programming process.
Copying Network and Device Information to
this Controller (Replication)
This controller is a secondary controller; you must copy (replicate) your
primary controller’s device and network information to this secondary
controller before trying to create or modify Groups and Scenes.