GE 45631 GE Z-Wave Wireless Keypad Controller - Manual (Page 14)

1. Put the primary controller into device delete mode so that
it can communicate with this secondary controller. Refer to
the instruction manual for your primary controller on how to
put it into this mode
2. Press and hold Add and Remove buttons at the same time
until the Orange LED blinks twice, then release.
3. Press and release the On (up arrow) side of the fourth
(bottom) Group/Scene button.
Restoring Factory Defaults
This device can be reset to its factory default settings. This deletes
all control network programming stored in the device.
1. Press and hold both the left side (OFF) of the #1 Group/Scene
button (upper left) and the “Remove” button until the Green
LED blinks twice (approximately 3 to 6 seconds depending on
the number of nodes in the network).
Functional Overview
This device is based on the Z-Wave Controller Library and the
Remote Controller Generic Device Class. It works with devices that
support the following Z-Wave Command Classes:
1. Basic Command Class.
2. Binary Switch Command Class.
3. Controller Replication Command Class.
4. Multi-level Switch Version 1 Command Class.
When using the Basic Command Class to control devices the
controller will either transmit a value of 0 or 99, depending on
the button Pressed.