Grizzly G0528 - Manual (Page 20)

-18-
model g0528 (mfg. 5/04+)
Router
To attach the router to the table:
1. lift the table assembly up and engage the
table braces on each side. ensure that the
table brace lock tabs are engaged completely
around the lock screws
(figure 16).
figure 16. locked table brace.
locked position
lock Screw
table brace lock tab
2. move the jack bolt lock nut (figure 17) on the
router clamp to the table side of the router
clamp if the router base mounting is
1 ⁄
2
" or
thinner.
figure 17. router clamp lock nut positions.
thick-base
routers
thin-base
routers
Jack bolt lock nut
figure 19. router clamp jack bolts.
4. loosen the router clamps enough to allow
the base of the router to press flat against the
underside of the cast iron table.
Note: The router spindle should be centered
under the cut out in the cast iron table.
5. adjust the jack bolts and the lock nuts on
each of the router clamps to allow the router
base to be secured against the table (
figure
19).
6. tighten the router clamps to secure the router
base into position.
3. Slide each of the four router clamps into the
t-slots on the underside of the cast iron table
(
figure 18).
figure 18. installing the four router clamps.
router Clamps
Jack
bolt
hands and fingers can become seriously
injured if they are pinched between the
stand edge and the table. DO NOT place
hands or fingers near the stand edge while
the table is in the raised position.