Grizzly G0528 - Manual (Page 10)

-8-
model g0528 (mfg. 5/04+)
figure 2. typical 5-15 plug and receptacle.
Grounding Prong is
Longest of the Three
Prongs
Current
Carrying Prongs Grounded
Outlet
110v Operation
full Load Amperage Draw
this router table is equipped with a 5-15, 110v, 15
amp receptacle, power cord, and power switch.
When selecting a router to use with this router
table, do not use routers that draw more than 15
amps under a full load.
power Supply circuit Requirements
the power supply circuit for the router table
muSt be grounded and rated for the amperage
given below. never replace a circuit breaker on
an existing circuit with one of higher amperage
without consulting a qualified electrician to ensure
compliance with wiring codes.
if you are unsure
about the wiring codes in your area or you
plan to connect your machine to a shared cir-
cuit, consult a qualified electrician.
minimum Circuit Size ............................. 15 amps
This machine MUST have a ground prong in
the plug to help ensure that it is grounded.
DO NOT remove ground prong from plug
to fit into a two-pronged outlet! if the plug
will not fit the outlet, have the proper outlet
installed by a qualified electrician.
Extension cords
We do not recommend using extension cords, but
if you find it absolutely necessary:
• use at least a 14 gauge cord that does not
exceed 50 feet in length!
• the extension cord must have a ground wire
and plug pin.
• a qualified electrician muSt size cords over
50 feet long to prevent motor damage.
SEcTiON 2: ciRcUiT REQUiREMENTS
Serious personal injury could occur if you
connect the machine to power before com-
pleting the setup process. DO NOT connect
the machine to the power until instructed
later in this manual.
Electrocution or fire could
result if machine is not
grounded and installed in
compliance with electrical
codes. compliance MUST
be verified by a qualified
electrician!
power connection Device
this machine comes with a plug, similar to figure
2, to connect the machine to power.