Grizzly G0528 - Manual (Page 19)

model g0528 (mfg. 5/04+)
-17-
Recommended cfM at Dust port: 150 cfM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
Miter
To attach the miter to the sliding table:
1. Secure the miter plate to the sliding table by
sliding the t-bolts into the table t-track.
2. position the miter plate in the desired position
and tighten the threaded star knobs.
Note: Do not worry about precise placement
of the miter plate at this time.
3. Secure the miter fence to the miter plate with
the threaded star knobs ( figure 15).
figure 15. installed sliding table fence.
miter
Fence
miter
plate
threaded
Star
Knobs
25. tug the hose to make sure it does not come
off.
Note: A tight fit is necessary for proper per-
formance.