Gateway GT704 - Manual (Page 47)

44
Actiontec USB/Ethernet DSL Gateway User Manual
45
Chapter 4 Using Advanced Setup
Remote Management
Selecting Remote Management in the “Configuring the Advanced Settings” screen
generates the “Remote Management” screen. Remote Management allows access
to the Gateway through the Internet via another computer. Actiontec recommends
leaving the Remote Management Off (the factory default setting).
To access the Gateway from the Internet, activate Remote Management by
selecting On and writing down the
WAN IP address of the Gateway (see “ WAN
IP Address”). On a computer outside of the network, open a Web browser and enter
the Gateway’s WAN IP address in the address text box. A username and password
prompt appears in the browser window. Enter your username and password to
access the Gateway.
☞
Note: Before Remote Management can be activated, the admin-
istrator password must be set. To do this, go to the Setup screen
and select Change Admin Password. Follow the instructions in
the subsequent screens.