GE EPM 3000P - Manual (Page 38)

Chapter 9 Programming GROUP 2: Meter Calibration
F OR FUNCTIONS 6 THROUGH 8, FOLLOW THESE STEPS :
NOTE: PRESS MAX/MIN/LIMITS, AT ANY TIME, TO CANCEL BEFORE STORING THE LAST DIGIT OR SWITCH.
MAX
AC VOLTS
A B C N
AC AMPS
MAX/MIN
LIMITS VOLTS PRINT
PROG PHASE
NEXT
2.
AMPS
B C A I I I
A B C
N N N I I I
A B C
LM2 LM1 MIN MAX
AC VOLTS
A B C N
AC AMPS
MAX/MIN
LIMITS VOLTS PRINT
PROG PHASE
NEXT
26.
AMPS
B C A I I I
A B C
N N N I I I
A B C
LM2 LM1 MIN
250
Step 1:
a. Enter Group Level of Programming Mode,
(see Chapter 6).
b. Press MAX/MIN/LIMITS until 2. appears in
upper display.
c. Press VOLTS to activate the Group.
A single dash appears indicating a one-digit
password is required to continue.
d. Press PRINT/PROG until 5 appears.
e. Press VOLTS to select.
Step 2:
a. Press MAX/MIN/LIMITS until 26. appears in upper
display.
b. Press VOLTS to activate.
Lower display blanks.
After 10 seconds, three dashes appear in lower
display.
MAX
AC VOLTS
A B C N
AC AMPS
MAX/MIN
LIMITS
VOLTS PRINT
PROG PHASE
NEXT
26
AMPS
B C A I I I
A B C
N N N I I I
A B C
LM2 LM1 MIN
I _ _
MAX
AC VOLTS
A B C N
AC AMPS
MAX/MIN
LIMITS
VOLTS PRINT
PROG PHASE
NEXT
26.
AMPS
B C A I I I
A B C
N N N I I I
A B C
LM2 LM1 MIN
Step 3: Step 4:
a. Press PRINT/PROG for desired number.
b. Press VOLTS to store.
When complete, lower display indicates the
calibrated reading after 10-15 seconds.
a. Press MAX/MIN/LIMITS at exit calibration sequence.
Proceed to calibrate another function, or exit.
See Chapter 12 to Exit.
33
GE Industrial Systems