Grizzly G1071 - Manual (Page 22)

-20-
model g1071 (mfg. 1/02+)
Sanding Sleeves
the model g1071 is supplied with 10 sanding
sleeves. use coarse grits for fast material removal
and a rough finish. use fine grits for slower mate-
rial removal and a smoother finish. When chang-
ing from a coarse sleeve to a finer sleeve on a
particular sanding project, avoid increasing the
grit number by intervals of more than 50.
To change the sanding sleeve on spindles
larger than 5 ⁄
8
":
1. disConneCt sander from poWer!
2. loosen the hex nut located on the top of
the spindle as shown in figure 23. the hex
nut and flange disk do not need to be
removed.
figure 23. Removing sanding sleeve.
NOTICE
Monitor the wear on the sanding sleeves.
The upper portion of the sanding sleeve
often gets very little use. If this is the case,
flip the sanding sleeve over and re-install.
This allows maximum use of the sleeve.
Worn sanding sleeves will not efficiently
remove material and can burn the wood.
3. slide the sanding sleeve from the spindle .
4. reverse Steps 1–2 to install a sanding
sleeve.
3. slide the sanding sleeve from the spindle .
4. reverse Steps 1–2 to install a sanding
sleeve.
To change the sanding sleeve on spindles 5 ⁄
8
"
and smaller:
1. disConneCt sander from poWer!
2. loosen the set screw located in the retainer
nut ( figure 24).
figure 24. Retainer nut set screw.