GE Monogram MONOGRAM ZV950 - Manual (Page 11)

11
Installation Instructions
5 CONNECT DUCTWORK
• Install ductwork, making connections in direction
of airflow as illustrated.
• Push duct over the exhaust outlet until it reaches
the duct stops.
• Secure joints in ductwork with sheetmetal screws.
• Wrap all duct joints with duct tape for an airtight seal.
• Use duct tape to seal the flange connection.
CAUTION:
Do not use sheet metal screws at
the hood flange connection. Doing so will prevent proper
damper operations. Seal connection with tape only.
PRUDENCE
Il ne faut pas utiliser de vis autoraurdeuses à la connexion
du collet de la hotte. Ceci empêcherait le bon
fonctionnement du registre. N’utiliser que du ruban
adhésif pour assurer l’étanchéité du raccord.
6 CONNECT ELECTRICAL
Verify that power is turned off at the source.
7 INSTALL DUCT COVERS
124Dia21
Mounting Screws
Bottom
Notches
124Dia27
Screw
Duct Tape
Over Seam
and Screw
Air Flow
Duct Tape
Over Flange
Duct Stops
WARNING:
If house wiring is not 2-wire
with a ground wire, a ground must be provided by the
installer. When house wiring is aluminum, be sure to use
U.L. approved anti-oxidant compound and aluminum-to-
copper connectors.
AVERTISSEMENT
Si la maison n’est pas câblée avec deux fils et un fil de
terre, l’installateur doit installer un fil de terre. Quand
les fils sont en aluminium, il faut prendre soin d’utiliser
des connecteurs aluminium à cuivre avec une pâte anti-
oxydante approuvée par UL.
• Insert house wiring through strain relief and tighten.
• Connect white leads to branch circuit white lead.
• Connect black leads to branch circuit black lead.
• Connect green/yellow leads to branch circuit green
lead or bare ground lead.
• Secure all connections with wire nuts on each electrical
connector.
• Push wires into junction box and replace cover. Be sure
wires are not pinched.
• Extend the inner duct upwards to the ceiling bracket.
• Secure the duct cover to the bracket with the 2 small
Phillips screws provided.
• Install the decorative screw in the lower left hole on the
duct cover as shown.
• Place the decorative duct
covers on top of the hood.
• Insert the lower portion
of the duct cover into the
impressions on the top of
the hood.