V-belt tension – Grizzly G0524 User Manual
Page 30

-28-
G0524 Rip Saw
— If end B is wider than end A, then the tip of
the fence needs to be adjusted to the right
to make the fence parallel to the blade
(
Figure 27).
Figure 27. Adjusting the fence to the right.
Figure 28. Cap screws to loosen fence.
3. Loosen the cap screws (Figure 28) on the
top of the fence to allow adjustment of the
fence. Retighten when complete.
4. Repeat step 1 to verify that the adjustments
are correct.
To adjust the main motor V-belt tension:
1. Disconnect the saw from the power
source!
2. Remove the side access panel to reveal the
adjustment mechanism.
3. Loosen the jam nut (Figure 29).
4. Adjust the turnbuckle to increase or decrease
the V-belt tension. Note—Turning the turn-
buckle clockwise lowers the tension and
counterclockwise increases it.
5. Retighten the jam nut when the V-belt has
been tensioned correctly and re-install the
side access panel.
Figure 29. Arbor motor V-belt adjustment.
A
B
Cap Screws
Jam Nut
Turnbuckle
V-Belt Tension
- G0506 (56 pages)
- 12" Cold Cut Saw G0682 (52 pages)
- G1127 (3 pages)
- 24" & 27" Resaw Bandsaws G3619 (56 pages)
- H7197 (1 page)
- INDUSTRIAL BANDSAW W/FOOT BRAKE G0513X2F (108 pages)
- Heavy-Duty Table G1023Z (63 pages)
- G0641 (56 pages)
- Air Cut-Off G8122 (2 pages)
- Ultimate 14" Bandsaw G0555 (68 pages)
- G4186Z (48 pages)
- H8145 (36 pages)
- G0691 (11 pages)
- G0691 (92 pages)
- G0592 (60 pages)
- Model G1022proz (84 pages)
- G0605X1-6X1 (12 pages)
- Model G1023zx3 (63 pages)
- G1016 (30 pages)
- H0604 (10 pages)
- ZX (63 pages)
- g0531b (8 pages)
- G3620 (56 pages)
- G1023SL (50 pages)
- G1023SLWX (3 pages)
- 50/65 Ton Ironworker G0647 (76 pages)
- Zero Clearance Table Insert H7396 (1 page)
- H7583 (28 pages)
- G0621 (60 pages)
- G0457 (64 pages)
- G0605X1 (101 pages)
- H0629 (3 pages)
- Slow Speed Cold Cut G0665 (40 pages)
- G0717 (60 pages)
- G0659 (60 pages)
- G0606X1 (12 pages)
- G0605X/G0606X (76 pages)
- G5787 (37 pages)
- G8599 (13 pages)
- T10131 (4 pages)
- G0513P (108 pages)
- G9906 (14 pages)
- G0513X2 (108 pages)
- G7211 (34 pages)
- G1052 (34 pages)