Grizzly G0524 - Manual (Page 27)

G0524 Rip Saw -25-
Inspect V-belts for damage or cracks after every
month (160 Hours) of regular use. The lube reservoir ( Figure 25) houses the oil that
lubricates the conveyor track. The oil is pumped
through a series of plastic tubes at a rate of 3-6
cc every 5 minutes, and onto a brush under the
main table. When the oil level in the reservoir
becomes low, a switch is triggered that prevents
the saw from being operated. If this occurs, fill
the reservoir above the “low” line and the saw will
operate normally.
Figure 25. Lube reservoir.
The sealed ball bearings in this machine are
permanently sealed and lubricated. There is no
need to lubricate them. If the bearing wears out,
simply replace it with one ordered from our ser-
vice department.
Lube System
Bearings
V-Belts