Furuno GP-1650WD - Manual (Page 51)

8-1
8. PLOTTER ALARMS
8.1 Introduction
There are five plotter-related alarms which
generate both audible and visual alarms:
Arrival alarm, Anchor Watch alarm, XTE
(Cross Track Error) alarm, Proximity alarm,
and Speed alarm.
When an alarm setting is violated the buzzer
sounds, and the speaker icon (
) appears
in red. You may silence the alarm by
pressing the [CLEAR] key. The icon remains
on the screen until the cause of the alarm is
removed or the alarm is deactivated.
8.2 Audio Alarm On/Off
The audio alarm sounds whenever an alarm
setting is violated. You can enable or disable
the audio alarm as follows:
1. Press the [ALARM] key to show the
ALARM menu.
DGPS 3D
ALARM
EDIT
CLEAR
ALARM
ALARM INFORMATION
AUDIO ALARM
ARRIVAL ALARM
ANCHOR ALARM
PROXIMITY ALARM
XTE ALARM
SPEED ALARM ON
ON 0.100nm
ON 0.050nm
ON
ON 0.100nm
OVER/UNDER
12.5 ~ 15.0kt
NO ALARM
Alarm menu
2. Press ▲ or ▼ to select AUDIO ALARM.
3. Press the EDIT soft key to show the
audio alarm window.
AUDIO ALARM
▲
ON
OFF
▼
Audio alarm window
4. Press ▲ or ▼ to select ON or OFF.
5. Press the ENTER soft key or the
[ENTER] key to register your selection.