FUJITSU M3096EX/GX - Manual (Page 34)

4 – 7
③
Pull up the ADF paper chute as follows:
• Hold the document cover with one hand and pull up the ADF
paper chute with the other hand to set the shaft in position B.
ADF paper chute
Document cover
15 to 20 mm
④
Fan the documents as follows:
• Take a 15 to 20 mm thickness of documents. Lightly hold both
ends with both hands. Bend the documents into an arch as
shown below.
• Then hold the documents tightly with both hands, and
straighten the documents. The center of documents swell and
air is introduced between the documents.
• Repeat this operation two or three times.
• Turn the documents 90
°
, and repeat the operation again.
Figure 4.3 ADF paper chute setting
Position for storage
position A Position for operation
position B
Shaft
Rotation direction
ADF paper chute