FieldServer FS-8704-13 - Manual (Page 19)

FS-8704-13 GE-SRTP Driver Manual
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 (408) 262-2299 fax: (408) 262-9042
Visit our website: www.fieldserver.com E-mail: [email protected]
Page 17
*SRTP:#6 FYI. Connect remaining bytes non-zero
This message requires no user action. It is intended for Fieldserver support engineers.
*SRTP:#7 Err. Destination request not supported.
*SRTP:#8 Err. Destination response not supported.
The driver has received a message that it cannot respond to. The message received is not normally
associated with reading / writing table memory and can be ignored by this driver. There is no
corrective action that you can take. If you wish, take a log file using RUIdebug and contact
Fieldserver support.
SRTP:#9 Err. Driver des not support unconfirmed messages.
The driver has been polled using a method which does not require confirmation. The driver does
not support this method. A panic is produced by this message. There is no corrective action that
you can take. If you wish, take a log file using RUIdebug and contact Fieldserver support.
SRTP:#10 Err. Session Mbox bad type. Act/Exp=%x/c0
SRTP:#11 Err. Session Mbox bad SR code. Act/Exp=%x/4f
SRTP:#12 Err. Session SR bad param. Act/Exp=%x/01
If this error occurs repeatedly or frequently then take a log using RUIdebug and contact support. If
infrequent then it indicate an occasional corrupt message. There is no corrective action you can
take to eliminate this error.
SRTP:#13 Err. Cant Process ServiceRQst=%x(h)
The driver cannot process this service request. It can only read/write table memory. There is no
corrective action you can take when this message is printed. If you wish, take a log file using
RUIdebug and contact Fieldserver support. The message is followed by a buffer dump. Recording
the buffer may be useful to Fieldserver support engineers.
SRTP:#14 Err. Cant Process Mbox=%x(h)
The driver cannot process this type of Mailbox message or a valild mailbox message was received
in an invalid context. If this message occurs frequently, take a log file using RUIdebug and contact
Fieldserver support. The message is followed by a buffer dump. Recording the buffer may be
useful to Fieldserver support engineers.
SRTP:#15 Err. Cant Process PDU=%x(h)
The driver can only process ‘connect’ and ‘data request’ PDU’s. . There is no corrective action
you can take when this message is printed. If you wish, take a log file using RUIdebug and contact
Fieldserver support. The message is followed by a buffer dump. Recording the buffer may be
useful to Fieldserver support engineers.
6.3 Scaling
The driver only supports scaling fro the following data types
Analog Inputs (%AI)
Analog Outputs (%AQ)
Registers (%R)
The scaling is only applied when the driver acts as a client.
When using scaling on an active map descriptor which writes data to a PLC ensure that the scaling
produces a number in the range 0-65536 ( an unsigned short integer).