FieldServer FS-8704-13 - Manual (Page 18)

FS-8704-13 GE-SRTP Driver Manual
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 (408) 262-2299 fax: (408) 262-9042
Visit our website: www.fieldserver.com E-mail: [email protected]
Page 16
10 GE_STAT_MBOX_NAK_MINOR
11 GE_STAT_MBOX_NAK_CNT
12 GE_STAT_MBOX_PROG_NUM
13 GE_STAT_MBOX_SWEEP
14 GE_STAT_MBOX_PLC_STAT
15 GE_STAT_MBOX_PRIV_LVL
16 GE_STAT_DEV_CONNECT_RESP
17 GE_STAT_SESS_CONNECT_RESP
18 GE_STAT_SESS_RESPONSE
19 GE_STAT_DEV_RESPONSE
20 GE_STA T_SLAVE_BAD_PDU
21 GE_STAT_SLAVE_SENDS_BAD_MBOX
22 GE_STAT_SLAVE_SENDS_OTHER_NAK
23 GE_STAT_SLAVE_BAD_SERVICE_RQST
24 GE_STAT_ERROR_PDU_RESP_COUNT
25 GE_STAT_ERROR_PDU_RESP_CODE
26 GE_STAT_RESPONSE_MSGS_RECD
27 GE_STAT_RESPONSE_BYTES_RECD
28 GE_STAT_POLL_MSGS_RECD
29 GE_STAT_POLL_BYTES_RECD
30 GE_STAT_RESPONSE_MSGS_SENT
31 GE_STAT_RESPONSE_BYTES_SENT
6.2 Driver Error messages
The following messages are produced by the driver and written to the error log which can be viewed using
the RUInet utility program or logged using the RUIdebug utility program.
Messages marked with a *, are only printed once and then suppressed to prevent the error log being filled
with repetitive messages.
SRTP:#1 FYI. The MapDesc called <%s> is too short.
You have define a map descriptor to expose driver statistics but the length parameter must be at
least 500 long. Ensure the Data array is this long too. Edit the CSV, correct he problem and reset
the Fieldserver.
SRTP:#2 FYI. You could have used a mapDesc called <%s> to expose diagnostic info.
You may safely ignore this message. Read section 6.3 for information on how to expose the
drivers communication statistics using a data array.
SRTP:#3 Error. MapDesc=<%s> has bad data type.
You must edit the CSV file, correct the problem and then reset the FieldServer to correct this
problem. Read the manual to get a list of valid data types.
SRTP:#4 Err. Address < 1 for MapDesc=<%s>.
GE references its data elements starting at one. You have a map descriptor with an address less
than 1. The driver will assume you meant an address of one until you edit the CSV file and reset
the FieldServer.
*SRTP:#5 FYI. Capability is non-zero
This message requires no user action. It is intended for Fieldserver support engineers.