beautypg.com

24 selecting unit of measurement for range, 25 selecting bearing reference, 26 watchman – Furuno 851 MARK-2 User Manual

Page 28

background image

2-19

2.24 Selecting Unit of

Measurement for Range

The unit of measurement for the VRM and
cursor can be nautical miles, kilometers, or
statute miles. You may select unit desired
as follows.

1. Press the [MENU] key.

2. Press the omnipad at 6 o’clock to

select Mode & Function and press the
[ENT] key.

3. Press the omnipad at 6 o’clock to

select VRM Unit.

4. Press the omnipad at 3 o’clock/9

o’clock to select NM, KM, or SM as
desired.

5. Press [ENT] followed by [MENU] key.

2.25 Selecting Bearing

Reference

Bearing can be displayed relative to ship’s
heading (relative bearing) or relative to true
north (true bearing) as follows. (True
bearing requires heading sensor input.)

1. Press the [MENU] key.

2. Press the omnipad at 6 o’clock to

select Mode & Function and press the
[ENT] key.

3. Press the omnipad at 6 o’clock to

select EBL Ref.

4. Press the omnipad at 3 o’clock/9

o’clock to select REL(ATIVE) or TRUE
as appropriate.

5. Press the [ENT] key followed by the

[MENU] key.

2.26 Watchman

How watchman works

The watchman function periodically
transmits the radar for about one minute to
check for targets in a guard zone. If it finds
change in the zone from the previous
transmission it sounds the aural alarm,
cancels the watchman function, and
transmits the radar continuously. This
feature is useful when you do not need the
radar’s function continuously but want to be
alerted to radar targets in a specific area.

Tx

St-by

St-by

Tx

1 min

1 min

5, 10 or
20 min

5, 10 or
20 min

Watchman
starts.

Figure 2-22 How watchman works

Turning on watchman

1. Create a guard zone (usually 360

degrees) with the guard alarm function.

2. Press the [MENU] key.

3. Press the omnipad at 6 o’clock to

select Mode & Function and press the
[ENT] key.

4. Press the omnipad at 6 o’clock to

select Watchman.

5. Press the omnipad at 3 o’clock/9

o’clock to select watchman rest interval
(amount of time until next rotation of
antenna); 5 minutes, 10 minutes or 20
minutes as desired.

6. Press the [ENT] key followed by the

[MENU] key. Then, WATCHMAN
appears, and the radar transmits for
one minute and then goes into stand-
by.